Alfa Romeo 4C Forums banner

Center out

1.3K views 19 replies 11 participants last post by  Jonty  
#1 ·
Center out.

Post yours
Image
 
#2 · (Edited)
Supersprint 🇮🇹 stainless steel exhaust (with endpipe kit 100 mm.)

Image

Image

Image

Image

(A piece of tape is visible on the right side: photos taken during the installation of the Koshi bumper cover)
 
#5 ·
Nice tips dude. (Just had to say that)

Actually, I agree. I just removed my quicksilver non-valved. Thought they looked cool and sounded great. Just didn’t flow like I wanted and take up more real estate. Swapping the track rod out was more problematic with side exits.

Current is GMS non valved resonated. Deeper, less bark, somewhat drone-y at ~3200 rpm w certain throttle input but sounds fantastic on over run and full throttle
 
#7 ·
The MF does rock for side exit.... they're soooo huge. I scored an Akrapovic finisher from a 458 so I had to use it. ;)
 
#13 ·
Although it can sound off, there's a muffler for each outlet so it's not stupid loud, and the valves open/close the outer ones. Drone goes away with valves closed. Yeah, I kept the side outlets because I didn't know how it was going to work out. Maybe time to look for the proper grilles
Image
 
#19 ·
Add fake tips to the side exits, see if you can pick up more chicks at the mall
Yeah, but the car doesn't want to go to the mall. I can't argue with it, the Mini Van likes to go. Tough old Honda takes door dings like my Pizza takes red hot pepper flakes ! Dammit, so uncool and yet how many chicks could pile in that....