Alfa Romeo 4C Forums banner
1 - 4 of 4 Posts

·
Registered
Joined
·
249 Posts
Ian, it may be just an angle of your photo, there is no way I can tuck the corner under since there is no groove close to the end. If you look at your stitching, it also starts outside and then goes under the lip after 5 or so inches.
 

·
Registered
Joined
·
249 Posts
There is no way - at least on my car, both because there is no grove under the carbon fiber for the roof to tuck into (check the area on your car) and also, the roof top is not long enough, meaning even if there was a grove in the front corner, the back part would be pushed too much towards the front and if you look at the photo below the edge in the back is pretty even. That is how it was designed. Unless his car is different but that is unlikely.

Car Vehicle Motor vehicle Automotive lighting Plant
 
1 - 4 of 4 Posts
Top